Curve.ToArcsAndLins

@timothytai wrote:

Hi,

Am I not understanding the Curve.ToArcsAndLins method correctly?
crv2Arcs_v1.gh (13.7 KB)

2019-03-21_10-44-15.png1916×944 111 KB

The tolerance parameters don’t seem to change anything, and the maximum length input seems to be counter-intuitive where when it is set at zero, minimum number of arcs are found and when it is increase to a large number (smaller than curve length), number of segments don’t seem to decrease. And when the minimum length is set to, say 5, many segment lengths are still smaller than 5.

Thanks!

Posts: 1

Participants: 1

Read full topic