Hi! I am trying to use the Bevel command in Grashopper for beveling mesh edges. The command is not directly available in GH but I was trying to call it using a GhPython script but I don’t seem to be able to find the method. I looked under the mesh class as well as the subD class and tried searching Rhinocommon for Bevel but nothing comes up. Beveling is quite an important command with regard to meshes and Subds and I can’t figure out why there’s very little trace of it outside of the Rhino command.
This might be noob question but would really appreciate if someone could point me in the right direction.
Thank you
1 post - 1 participant