@hjandersen wrote:
Hi all,
I have some items with gaps in them. From a database I have the widths of the parts that have to go into the gaps. The problem is to widen/narrowing each gap based on the width from the database.
In attached gear the gaps is going to be between 2.5 and 3.5.
The strategi is to turn on the grips for each gap and then move some grips (in these case half-1) in one direction and the other grips in the opposite direction (the purple line indicating the direction).
I have most sorted out, but I have trouble finding a reliable way to find the direction.
Any suggestions?
Hans
Widen the gab.3dm (121.5 KB)
Posts: 2
Participants: 2